Owners: Mount Melville (1854-57) - Losh,
Wilson & Bell
St Andrews Coal Co. (1860)
Whyte Melville (?)
Near Lumbo, close to the present Craigtoun Park, St
Andrews, and to the south at Winthank and Feddinch, several
small workings, including No. 2 Pit on Mount Melville
Estate (exact location not known), worked coal and
ironstone in the 19th century. Details of the ironstone and
of the associated strata are known from records of the
ironstone workings and from boreholes put down around
1855.
Click on Maps to Zoom
In
Extracts from Statistical Account of Fife
St Andrews Parish - 1795
" ... Coal is in great abundance within a few
miles of the city; much also is imported from both sides of
the Forth, chiefly from Dysart, Alloa, and
Borrowstounness [Bo'ness]. The proper weight of a
St Andrew's cart-load, or boll of coals, is 75 stone, or
1200 pounds. The average price of this cart-load, including
carriage, has hitherto been from the adjacent mines, 5s.
Dysart, 5s. 4d. Alloa, 5s. 10d. Borrowstounness, 6s. 4d.*
* During the winter 1792-3, St Andrew's sufferred under
the general complaint of scarce and dear coals. The moor
coals were raised to 6s. 6d. Dysart and Alloa to 8s. 9d.
Borrowstounness as high as 11s. ...
... On Denhead moor, in the S.W. corner of the parish, and
on the confines between it and that of Cameron, a coal-mine
belonging to Mr Martin of Denbrae, has sometimes been wrought
to a small extent. On the same moor, Mr Durham of Largo has a
coal. None of these are now occupied. Two or three years ago,
some Englishmen, judging from the appearance of the ground,
expected to find coal in many different parts of the parish,
and entered into contract with several proprietors; but,
after expending a good deal of money in boring, &c. they
were disappointed. ... "
Extracts from Statistical Account of Fife
St Andrews Parish - 1845
" ... The prevailing strata are sandstone,
containing thin seams of coal, and strata of slate clay, with
courses of clay ironstone; thus indicating that the whole
group belongs to the carboniferous series.
... And what gives the slate clay a certain degree of
economic interest, are the courses and thin beds of clay
ironstone which it usually contains and which, at a time when
the iron trade was more profitable than it is now, were
sometimes collected and sent off to the Carron Ironworks. ...
... No mines are at present wrought, but it is understood
that coal, though of an inferior quality, might be procured
at Denhead, near the south-west extremity of the parish. ...
"
Information on coals worked at, or near,
Lumbo, St Andrews
(based on a report from 1900)
The coal-bearing strata of the East of Fife were more
broken up with large faults than they were in the Central and
Western parts of the Kingdom, and much more disrupted and
altered by the intrusion of igneous rocks. There can be no
doubt that these drawbacks arrested the development of coal
mining in the district. Much of the workable coal was
exhausted down to shallow depths before the end of the
nineteenth century and the deeper parts, together with those
where the workings were stopped by faults or by injected
whinstone, have only been worked for a few years into the
twentieth century. Most of the coal-mining was carried on
here before pumping machinery had arrived and it was
abandoned when the engine then in use could no longer keep
down the underground water. It is to be feared that older
mining plans of many portions of the old East Fife
coalfields, formerly largely worked, have been either lost or
destroyed, and that little or no information now exists
regarding the structure and condition of these tracts.
Happily, by an Act of Parliament, it eventually became law to
officially deposit copies of all mining plans in the Home
Office, where they are ultimately available for future
guidance.
The same coal seams encountered in the Denork and Denhead
areas were encountered in the workings at Lumbo, and above
them the Parrot Coal. The ironstone seam was combined with
some parrot coal, coaly shale and cherry coal as indicated in
the following table:
| Description |
Thickness |
| Shale |
- |
| Parrot Coal |
5 in. |
| Coaly shale and coal-streaks
("Rums") |
1 ft. 1 in. |
| Brown-stone (Ironstone) |
5 in. - 7 in. |
| COAL (cherry) |
1 ft. 6 in. |
| Shale |
- |
Like other blackband ironstones, this seam underwent great
variation in thickness and quality as it was followed from
place to place, these changes arising with remarkable
rapidity. Thus, a short way further south on the Mount
Melville estate, close to the boundary with Feddinch, the
seam had the following composition and thickness:
| Description |
Thickness |
| Fireclay |
- |
| Parrot Coal |
5 in. |
| Coaly shale ("Rums") |
1 ft. |
| Brown-stone (Ironstone) |
1 ft. 8 in. |
| Clay |
- |
... and in a report from 1977 ...
The Winthank or Denhead Blackband Ironstone is present in
the Radernie Duffie Coal in a small faulted syncline near
Lumbo farm. ... The details of the Radernie Duffie Coal
closely resemble those of the seam at Denhead. The following
general section is based on borehole and pit records:
| Description |
Thickness |
| Cannel coal and carbonaceous shale |
17 - 22 in. |
| Blackband ironstone |
5 - 23 in. |
| Fireclay |
0 - 4 in. |
| Coal |
18 - 20 in. |
In Lumbo No. 3 Borehole the seam was interleaved with thin
basalt sills, and in a bore put down from the bottom of No. 2
Pit on Mount Melville estate around 6½ fathoms of
dolerite were encountered. These occurrences suggested that
the Lumbo dolerite sill, seen at the outcrop in Lumbo Den,
lay just below the Radernie Duffie Coal. ...
... The Radernie Brassie Coal was formerly worked to a
small extent as the Low Little or Low Lime Coal at
Cassindonald Colliery and in the area between Winthank
Limeworks and Denhead. According to old reports by mining
engineers, its thickness varied between 18 in. and 26 in. but
there was no record of the Brassie Coal at Lumbo. ...
... At Lumbo the upper leaf of the Largoward Black Coal
was proved in the Mount Melville No. 3 Borehole (1855) where
it was 2 ft. 7 in. at a depth of 23 fathoms. ... Like the
underlying Largoward Black Coal, a full section of the
Largoward Splint Coal seam was encountered in the same
borehole in the Lumbo area. The details are shown in the
table below: ...
| Description |
Thickness |
| Cherry Coal |
1 ft. 7 in. |
| Rums |
6 in. |
| Parrot Coal |
1 ft. 6 in. |
| Cherry Coal |
8 in. |
These details compared well with those recorded in a small
working (1866) nearby - possibly Mount Melville No. 2
Pit?
| See also Coalfields link: Old
Coalfields of East Fife |
|