Owners: not known
There are several records indicating the working of coals
at Balcaskie from early times and even predicting where
future coal workings would probably be successful.
Click on Maps or Image to Zoom
In
Statistical Account of Fife (Pittenweem)
1793
"The colliers are all free, stand engaged by the
year, and are paid in proportion to the work they
respectively perform. A good and laborious collier will earn
about eighteen shillings a week."
Statistical Account of Fife (Anstruther
Wester) 1845
"... the parish ... consists of ... the inferior
coal measures, ... the carboniferous limestone ... and the
upper or true coal measures. ...
... The coal not being worked in this parish, it can only be
judged of from the workings in the neighbourhood of
Pittenweem. There it [the true coal measures] consisted of
seventeen beds, making an aggregate thickness of 82 feet 6
inches. Of course, only a few of the lower coals can make
their appearance in the parish of Anstruther, as they crop
out to the eastward. Faults and dislocations of various kinds
derange them so frequently, that it is impossible to state
with certainty what may be found to the north-west of this
parish. This, however, we know, that two seams are wrought at
Balcaskie; and as the dip is moderate, and these not
apparently the lowest, the cropping of still lower seams must
lie between Balcaskie and Grangemuir. ...
... There are no mines of any description in the parish,
though coals have been worked a few hundred yards from the
boundaries, at Waterriggs and Balcaskie. During summer 1838,
borings for coal were made by Lord William K. Douglas; but
thin seams only were passed through. These trials seem to
have been made too far to the eastward, as the workable seams
of the St Monance basin must crop out considerably further
west. If coals shall ever be discovered in this parish, it
must be between Grangemuir and Balcaskie, and subjacent to
the two Kellie seams now in process of working. ...
... A considerable quantity of ironstone is to be found
along the shores of the burgh, which the magistrates let for
1s. per ton; and it is afterwards quarried and collected and
shipped for Newcastle. ... There are appearances of coal in
the parish at different places; and the name given to some
acres lying north-east from the glebe, viz., the Cowpits or
coal-pits, seem to indicate that the mineral had formerly
been wrought here. Last winter, many of the inhabitants got
liberty from the magistrates to dig coal at the seashore,
below flood-mark, and supplied themselves with many
cart-loads."
Information on coals worked at the
Balcaskie pits
(based on a report from 1900)
The most southerly point of the known outcrop of the
Kellie Coals was about 400 yds. north of Balcaskie House,
where a line of old pits indicated former workings up to a
fault line having a southerly downthrow of 40 yds. The exact
number and location of these old 'Balcaskie pits' is
not known but the workings ran northwards until, within 100
yds. of Kellie Castle, a large east and west fault, having a
downthrow to the south of 180 yds., was found to shift the
coal outcrops about 700 yds, to the west (see sketch map). It
is reported that as the miners approached this fault, the
Fore Coal increased in thickness to 13 ft. and the dip became
more rapid. North of this fault, the coals were found to be
crossed by two 'trap-dykes' which did not shift them
but which converted them into a kind of anthracite or
'blind coal'.
The "Kellie Coals" were apparently quite well
known and commercially important in this area of east Fife.
They comprised two seams; the lower seam, called the
'Fore Coal', was described as being from 4 ft. 6 in.
to 7 ft. thick, with a shale parting 2 in. thick
approximately 2 ft. from its pavement, and 3 in. of
slate-clay near its roof, which was composed of hard
shell-limestone about 3 ft. thick. The upper coal seam was
known as the 'Back Coal' and it lay 132 ft. higher in
the series. It was described as being 9 ft. thick, with three
shale partings in it, about equal distances from each other,
and there was 9 ft. of roof composed of hard, black,
bituminous slate.
A record of the seams from 1870s bores is given below:
| Back Coal (The Upper
Seam) |
| Coal |
9 in. |
| Stone |
1 in. |
| Coal |
1 ft. |
| Fireclay - coaly |
6 in. |
| Coal - clean |
2 ft. 3 in. |
| Coal - brassy |
6 in. |
| Coal |
8 in. |
| Fakes |
1 in. |
| Coal |
9 in. |
| Fakes |
1 in. |
| Coal |
1 ft. 3 in. |
| Fireclay |
- |
| Total thickness |
7 ft. 11 in. |
| Fore Coal (The Lower
Seam) |
| Coal |
2 in. |
| Coal - soft |
4 in. |
| Stone |
½ in. |
| Coal |
1 ft. 3 in. |
| Fakes |
1 in. |
| Coal |
1 ft. 6 in. |
| Fireclay and fakes |
- |
| Total thickness |
3 ft. 4½ in. |

|